Cheer Bow - Instruction Template Download

Question

Q: I purchased the rhinestone cheerbow pack quite a while ago but i still can't figure it out. Is there a BETTER video on it? The only video I find is short and doesn't help me. I also do not have tic tok or any other ones except u tube. Thanks, Sandy

Asked by: Sandy Sessink - 4/11/2024

Submit an answer

Q: Is this template for short tails or long? I usually use 30 inches of ribbon, how much does your template use? I've kinda eyeballed it in the past and wanted to do them a bit better

Asked by: Andrea M Leggett - 5/12/2022

Submit an answer

Q: How long do you cut the ribbons for the cheer bow?

Asked by: Sandy - 4/10/2022

Submit an answer

Q: What is the width of the ribbon used in the cheer bow? Thank you! Cindy

Asked by: Cindy Losekamp - 4/20/2022

Submit an answer

Q: Can I use my points to get bow?

Asked by: Laura Trevino - 1/6/2023

Submit an answer

Questions about this item? Ask here.

TRW Pilar (4/13/2024) · Accepted Answer

Hi there!

I did start a longer video, explaining how to take the section where the two ends or tails of the bow cross over each other and align the top center part to the center of the overlap. The video got to be over an hour long, so yes, I should do a video that is longer than a minute but not a full hour. I'm putting that on our to-do list.

Basically, take your length of grosgrain ribbon and fold in half. Press a crease there at the center. Use the included printable template and line up the crease to the center line on the template. Take the right half and fold over at an angle, following the lines on the template. Take the left half and cross over the top of the right half, again, following the lines on the template. You'll see the angles at the top of the template are equal distance from the center line, which makes the loops of your bow equally sized.

Now, pinch where the two tails overlap and align that center to the crease OR slip the top section with the crease to be centered where the tails overlap. You'll have 3 layers of ribbon in your hands. I like to have 3 folds in my bows that run horizontally or from left to right.
Make the biggest fold right in the middle of those 3 layers and pinch tight with your fingers. Then, make a small fold below that and a small fold above that bigger fold. You'll be able to see the 'bow shape' start coming together at this point. Take a Ponytail holder and put a zip tie through it, then wrap the zip tie around the center folds. The Zip Tie holds the folds for you and if you don't cinch it down fully, you can make slight adjustments to your bow. I like to pull the loops up from the center and make sure they're the same height, then match the bottom points to make sure they're even. You can gently tug on either side of the 'Loops' or 'Tails' to adjust. Now, pull the zip tie tight and cut off the excess plastic.

You'll need to use hotglue for the thinner center ribbon. 1/4" - 1/3" wide usually fits beautifully. Put a Tiny dot in the center of the front of the bow on the zip tie and place the center ribbon there. Wrap the ends to the back and hot glue over the clip of the zip tie. Careful to not burn your fingers with the hot glue!

Trim any excess ribbon and any hot glue 'strings'.

Hope these detailed instructions help until we can put together a longer video with a voice over to walk you through making your own bows.

TRW-Crystal (5/13/2022) · Accepted Answer

A: For short tails.
.
.
.
.
Cheer Bow - Instruction Template Download

Was this answer helpful? 0 of 1 Customer(s) found this Answer helpful.

Answer provided by: TRW-Crystal (5/13/2022)

TRW-Crystal (4/11/2022) · Accepted Answer

A: There are two downloads in this listing. One is for the templates, and the other is a picture instructional which includes the length and steps in order.

Cheer Bow - Instruction Template Download

Was this answer helpful? 0 of 0 Customer(s) found this Answer helpful.

Answer provided by: TRW-Crystal (4/11/2022)

TRW-Crystal (4/20/2022) · Accepted Answer

A: There are two downloads in this listing. One is for the templates, and the other is a picture instructional which includes the meaasurements and steps in order.

Cheer Bow - Instruction Template Download

Was this answer helpful? 0 of 0 Customer(s) found this Answer helpful.

Answer provided by: TRW-Crystal (4/20/2022)

TRW Pilar (1/8/2023) · Accepted Answer

Yes, you can use your points for designs or fonts. If you have enough points, there will be a black box right under the Add to Cart box, which offers to let you redeem points for the download. Click that box if you'd like to use your points for the purchase.

Cheer Bow - Instruction Template Download

Dance Bow Template Craft

This Cheer Bow Template Craft Instant Design Download Includes:

Q: I purchased the rhinestone cheerbow pack quite a while ago but i still can't figure it out. Is there a BETTER video on it? The only video I find is short and doesn't help me. I also do not have tic tok or any other ones except u tube. Thanks, Sandy

Q: Is this template for short tails or long? I usually use 30 inches of ribbon, how much does your template use? I've kinda eyeballed it in the past and wanted to do them a bit better

Q: How long do you cut the ribbons for the cheer bow?

Q: What is the width of the ribbon used in the cheer bow? Thank you! Cindy

Q: Can I use my points to get bow?

Related Items

You May Also Like